Programming stepper Driver 2DM2280 with Zelio PLC
Posté : 15 janv. 2025, 10:57
I am new to this, I need to programme a 2DM2280 stepper driver with a Zelio PLC.
My questions are how to connect the STEP and DIR with the PLC's outputs, and i found it hard to create the programme that counts the steps and stops at a specific position while maintaining the same direction then go back to its original position backwards with the same steps.
Any language of programming is welcome help.
Thank you
My questions are how to connect the STEP and DIR with the PLC's outputs, and i found it hard to create the programme that counts the steps and stops at a specific position while maintaining the same direction then go back to its original position backwards with the same steps.
Any language of programming is welcome help.
Thank you